← All guides
Spray Mop – How to Use
This mop has a water bottle. Press the button and water sprays in front of the mop.
中文版 ↓
1. Fill the bottle
- Take the bottle off the mop. Open the cap.
- Pour in water. Fill the wide part, then keep pouring until the small neck is more than half full.
- Add floor cleaner to fill the rest of the neck.
- Close the cap. Shake a little. Put the bottle back on the mop.
Most of the bottle is water. The water goes past the middle of the neck. Floor cleaner fills only the top of the neck.
A lot of water. A little cleaner.
2. Mop the floor
- Press the button. Water sprays in front of the mop.
- Push the mop forward. Do not push and pull back and forth.
- Keep the dirt in front of the mop.
- When the floor is dry and the mop is hard to push, spray 2 times. Then keep mopping.
3. Wash the mop cloth
- Rinse the dirty part of the cloth under running water.
- Put the mop on the floor. Step on the cloth to press out the water.
- The cloth does not need to be very dry. It dries by itself as you mop.
4. Good to know
- Use this mop on tile floors.
- Use only the floor cleaner the family gives you.
- Do not mix floor cleaner with bleach or other products.
- Ask the family before adding disinfectant or alcohol to the bottle.
噴水拖把使用說明
這支拖把有一個水瓶。按下按鈕,水會噴在拖把前面。
1. 裝水
- 把水瓶從拖把上取下,打開瓶蓋。
- 倒水,先裝滿寬的部分,再往上倒,倒到細瓶頸超過一半。
- 加地板清潔液,只加瓶頸最上面剩下的那一小段。
- 蓋上瓶蓋,輕輕搖一搖,把水瓶裝回拖把。
瓶子大部分是水,水要超過瓶頸的一半。清潔液只加瓶頸最上面那一小段。
2. 拖地
- 按下按鈕,水會噴在拖把前面。
- 拖把往前推。不要前後來回推拉。
- 讓髒東西一直留在拖把前面。
- 地板乾了、拖把變得難推時,噴 2 下水,再繼續拖。
3. 洗拖把布
- 把布髒的地方放在水龍頭下沖乾淨。
- 把拖把放在地上,用腳踩布,把水壓出來。
- 布不用很乾,拖著拖著自己會乾。
4. 注意事項
- 這支拖把用在磁磚地板。
- 只用家人給你的地板清潔液。
- 地板清潔液不要和漂白水或其他產品混在一起。
- 要在水瓶裡加消毒液或酒精,先問家人。